Zeros and ones Posted September 4, 2017 Share Posted September 4, 2017 So I have the Asus Rog Zenith Extreme. Sad to say it only had one USB Header. So I bought the NZXT Internal USB Hub. That is what is connected to the USB header on my mother board. the Commander Pro is connected to the NZXT. I know that it is working as needed because my CLC h115i and my AX1200i that is connected to my Commander is working. The fans that are connected to my commander are not working. Also my LED strips that I have connected to the Commander are not functioning either. Below I have a very rudimentary drawing of what this mess looks like in my rig: Asus Rog Zenith Extreme --> NZXT Internal USB Hub --> Commander Pro. AX1200i and H115i --> Commander Pro (These are working) Noctua Industrial 2000RMP fan and two Corsair LED strips --> Commander Pro (These are not working) Some assistance would be nice. Thank you. Link to comment Share on other sites More sharing options...
red-ray Posted September 4, 2017 Share Posted September 4, 2017 Noctua Industrial 2000RMP fan and two Corsair LED strips --> Commander Pro (These are not working) You need to have updated to the CLCP V0.2.136 firmware for Noctua fans to work, have you? See http://forum.corsair.com/forums/showthread.php?p=914468 What does the CLCP detect the fans as? The only way I know to check is to look at the [Link Fans] panel of my SIV utility. You could also try using [Link LEDs] to see if SIV can get the LEDs to work. Link to comment Share on other sites More sharing options...
Zeros and ones Posted September 9, 2017 Author Share Posted September 9, 2017 My noctua fans that have three pins work fine but my nactua that have 4 pins only spin for a second and than shut off. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.