Jump to content
Corsair Community

H100i V2 - AM4 - Screw into backing plate


common47

Recommended Posts

Hi all,

 

I was wondering if you fine folks could help me out.

 

I have an AM4 motherboard and the H100i V2. Now I have removed the stock mount, the issue I am having is that the supplied AM4 standoff screws do not screw all the way into the backing plate. The previous screws were flush the the end part of the backing plate. These ones are not. They go about 1/4 of the way in and that is it. Hardly using any thread of the inside of the backing plate part.

 

I am using the supplied screws that have the collar on (http://www.corsair.com/en-us/am4-amd-retention-bracket-kit-for-hydro-series-coolers)

 

I also have the screws without the collar on them, however, if I use 4 of those I can grab them and pull/push the backing plate freely, it is not secure.

 

Any advice?

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...