Jump to content
Corsair Community

Shuttle SN85G4V2 and TWINX1024-3200XL


Recommended Posts

I have been having a lot of trouble getting this RAM to run properly in my system. Whenever I have both sticks in, it will randomly crash and will not display anything on the screen when I try and reboot. To fix this, I have to pull out one of the sticks of RAM (after which I can put it back in again). And it really doesn't matter which stick I leave in - the problems only occur when they're both in there at the same time. I have the voltage set at 2.7v and have even tried 2.8v to no avail. My timings are 400 MHz at 2-2-2-5. Any ideas?
Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...