igggii Posted January 16, 2005 Share Posted January 16, 2005 I have 3 MSI Neo-FSR boards with the same issue. I have 2 CMX512-3200C2PT sticks in each and I can not get XP to even install. Whern I run MEMTEST I get hundreds of errors but only on test #7. I have tried the default Bios setup as well as some of the ones listed all over the internet for Corsair memory. What should these be setup as? Are there other tests I can run that would give me more info? Link to comment Share on other sites More sharing options...
Wired Posted January 16, 2005 Share Posted January 16, 2005 Do they work with one stick in? What slots are the memory in? What version is each stick? How To Read the Memory Label Link to comment Share on other sites More sharing options...
igggii Posted January 16, 2005 Author Share Posted January 16, 2005 They do not work with one stick in. I have tried them in slots 1,2 and 3. The version is 5.1 and these are the TwinX Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted January 18, 2005 Corsair Employees Share Posted January 18, 2005 With 2 modules they should be in slots 1-3 or 2-3. Link to comment Share on other sites More sharing options...
igggii Posted January 18, 2005 Author Share Posted January 18, 2005 With 2 modules they should be in slots 1-3 or 2-3. I have done that but it did not work. I have tried it with just 1 module as well. What should be the proper setting for this ram. This is an Intel box. Link to comment Share on other sites More sharing options...
igggii Posted January 18, 2005 Author Share Posted January 18, 2005 I have done that but it did not work. I have tried it with just 1 module as well. What should be the proper setting for this ram. This is an Intel box. Is there a better board that I should be looking at? Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted January 18, 2005 Corsair Employees Share Posted January 18, 2005 Are both modules exactly the same part# and revision? Dim Voltage to +2.7 Volts: CAS Latency CL=2.5 Row Cycle Time tRC Bios Default Row Refresh Cyc Time tRFC Bios Default Ras# to CAS# delay tRCD 3 Row to Row delay Bios Default Min Ras# Active Time tRAS 7 Row Precharge Time tRP 3 Write Recovery Time Bios Default Write to Read delay Bios Default Read to Write Delay Bios Default Refresh Period tREF Bios Default Enable 2T Timing Disabled Then test the system with http://www.memtest.org and make sure it's stable! If you have problems, I would set Enable 2T Timings to AUTO and test it again! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.