Memhorder Posted December 26, 2016 Share Posted December 26, 2016 Hi there. Very curious before I order parts if I could fit a 60mm thick x 240 mm L Radiator up top for a custom loop on CPU. If not then I'll have to up it to 360mm in front :sunglasse Link to comment Share on other sites More sharing options...
c-attack Posted December 26, 2016 Share Posted December 26, 2016 Hard to say. No problem with the case, but sometimes you run into motherboard and memory height issues. Those will likely be the determining factor. You can see in this shot, the 240 slots are off-set from the board quite a bit. That should make board top heatsinks a non-issue, but watch your Dominator platinum or other very tall modules. However, you may want to visualize how the build will look with approximately 85mm of top hardware coming down. The 570 has a lot more room up top than it's 460X sibling, but I wonder how much of the board this will obscure and possibly a portion of the rear fan as well. There is a ton of space in the front, although there are the obvious air management issues with running a full radiator across the intake. Just something to consider. Link to comment Share on other sites More sharing options...
shyamprakash007 Posted December 26, 2016 Share Posted December 26, 2016 Depends on the type of Motherboard u r using[Heatsink may interfere with the clearance] and also RAM with sinks like Corsair vengence might cause a clearance issue on top.. Better mount the radiator in the front...It also looks good... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.