Jump to content
Corsair Community

H100i v2 / Asus Z170-E Fitment


mbaran

Recommended Posts

Some Asus boards appear to be slightly thinner than standard, however, when you tighten the cooler pump down it should tighten up so that the pump doesn't move, but make sure not to over-tighten it, otherwise you may damage your cpu. Assuming that you are using the correct stand offs, if it doesn't tighten up correctly you can put some rubber/fibre washers on to tighten it up.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...