Jump to content
Corsair Community

VS1GBKIT400 +Asus a8n-sli dlx.= Problems


Recommended Posts

Help I recently purchase a Asus A8N-SLI deluxe and some of your vs pc3200 1gb kit, I have had a god aweful time with this I have followed the instructions on which banks to mount these modules and have met with blue screens and memory failures galor I have installed xp pro twice and have sucessfully booted up my computer a total of 5 times the Ram just plays havic in my computer. I pulled one stick and sucessfully loaded windows the second time but when I rebooted I first got a blue screen of death with mem addresses and then I ran debugg and now windows will boot but I now have no font at all everything is in squares and / Please help I have run out of things to do I Have a MCP and my buddy which has also looked at it is a lisenced a+ and both of us think it is the ram. Currently I have one stick in the B2 dimm slot. I have tried evry combo it tells me to in the book. Below is a list of my system specs.



AMD 939 pin 3200

Asus A8N-SLI Deluxe Board with default BIOS


Ati x700pro 256

Demon 580 watt PSU

Windows XP PRO

Link to comment
Share on other sites

  • Corsair Employees

Please test the modules one at a time with http://www.memtest.org and I would set the Dim Voltage to 2.7 Volts as well. In addition you might set the timings manually as well.

CAS Latency CL=2.5

Row Cycle Time tRC Bios Default

Row Refresh Cyc Time tRFC Bios Default

Ras# to CAS# delay tRCD 3

Row to Row delay Bios Default

Min Ras# Active Time tRAS 8

Row Precharge Time tRP 3

Write Recovery Time Bios Default

Write to Read delay Bios Default

Read to Write Delay Bios Default

Refresh Period tREF Bios Default

Enable 2T Timing Enabled

Then test the system with http://www.memtest.org and make sure it's stable!

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...