Jump to content
Corsair Community

Memtest86 Errors


Recommended Posts

I've had a few problems with games every so often, system will just freeze of give me BSOD. Looked around the net and found most found the problem with memory.

 

so I did a test with memtest86 and found the following returned an error every time the test was run:

 

Failing Address - 0001EB2352C 491.1MB

good/bad - c0fbfd8f

Err bits - 20000000

Chan 1

 

 

 

[Processor]:AMD Athlon XP 3200+ 400FSB

[Memory]:1Gb Corsair XMS Platinum CMX512-3200LLPT

[HDD]: Maxtor 160Gb SATA

[MOBO]:Asus A7N8X-E Deluxe with 1013 firmware

 

Sapphire 128Mb Ati Radeon 9800pro

Driver Version: 6.14.10.6497

Direct3D Version: 6.14.10.0277

OpenGL Version: 6.14.10.4776

 

Windows XP Pro SP2 (5.1 Build 2600)

DirectX 9.0c(4.09.0000.0904)

Link to comment
Share on other sites

  • Corsair Employees

Please make sure that you have the jumper set from the default 1-2 setting to 2-3 and the have modules installed on either slots 1&3 or 2&3; also make sure that you have the latest BIOS for your MB, load Setup/Optimized default settings, and try the following BIOS settings;

TwinX1024 or TwinX512-3200LL

CPU Freq: 200 MHz (400 FSB)

System Performance: User Define

Memory Frequency: 100%

Resulting Frequency: 200 MHz (400 FSB)

Memory Timing: User Define

SDRAM CAS Latency: 2T

SDRAM RAS to CAS Delay (tRCD): 3T

SDRAM Row Precharge (tRP): 2T

SDRAM Active to Precharge Delay (tRAS): 6T

DDR Reference Voltage: 2.7 Volts

AGP Voltage: Default *unless you have ATI (9200 or 9600) or NVIDIA (5200 or 5700) then 1.6 Volts suggested!*

All other settings are motherboards defaults

Then please test them one at a time with http://www.memtest.org and let’s make sure it's not some other issue! I would run the test for at least 2-3 passes to be sure!

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...