Hammerdown Posted November 28, 2016 Share Posted November 28, 2016 Updated link to the new version and now the led, fans and pump are not recognized in win 10. The firmware is also showing version 0.0.0. What is going on here? Any help is greatly appreciatd.:mad: Link to comment Share on other sites More sharing options...
Hammerdown Posted November 28, 2016 Author Share Posted November 28, 2016 I have tried everything that I could find on here and nothing is working. Uninstalled old version. Rebooted.Installed new version of CL. Rebooted. Then some how both the old and new opened up on start. Fans were varying speed and the led were flashing between red and white. Rebooted. Now the fans run fast and can't control anything. Please help. Link to comment Share on other sites More sharing options...
snapper69 Posted November 30, 2016 Share Posted November 30, 2016 I had 3 H100i's bricked by the firmware update ( I know. I'm a slow learner, but I didn't have a clue what happened the first time, I wasn't sure the second time but after the third time, the penny dropped) I would see if the firmware has crashed, switch your computer off, disconnect the power lead and press the power button on the front for a few seconds, then leave it for 5 minutes. You can then reboot it and see if that helps. If it doesn't, I would start an RMA ticket, using the Support Ticket System button at the top of the page. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.