Jump to content
Corsair Community

H100i V2 - Power Supply/Draw


gladi

Recommended Posts

Hey

I just unpacked my H100i V2 and noticed it only has the 4 pin and USB connector.

 

Does that mean the connected fans and the pump get power over the 4 pin from the mainboard?

Is that not a little to "much" for a single 4 pin connector?

Link to comment
Share on other sites

The H100iV2 get's it's power from the 3-pin fan connector that you should plug into the motherboard CPU_FAN header. It needs a constant +12 volts and uses <= 1.0 amps.

 

Note that you must disable fan control for the CPU_FAN header in the BIOS so it get's this.

 

The 4-pin USB connection is just used to control the H100iV2.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...