Scrollwheel Sticker loose (Sabre)

[FlygarStenen]

I bought a Sabre RGB some time during December 2015 or January 2016, and after a couple of weeks using it I noticed that there was a sticker on the scrollwheel that had come off a bit. I did not mind about it up until recently.

 

The thing is that it has come off so much that my fingertip comes between the sticker and the scrollwheel. It sort of feels like if you have a thicker paper (just thick enough to not give you a paper-cut) scraping the fingertip.

 

First of all I feel a bit disappointed that stickers are used instead of actual plastic.

 

Secondly, is there any way to solve this? I do not feel comfortable using glue on the scroll-wheel (for obvious reasons). And if I'd remove the sticker(s) on the scroll-wheel that would not look very good in my opinion (I wouldn't buy an RGB mouse if I didn't care how it looked)

 

I have attached pictures of how it looks and how it should look, it might be a bit hard to see but I do not have better camera equipment than my phone available.