Jump to content
Corsair Community

K95RGB Macros Won't Run


Justy

Recommended Posts

1. I did read the Corsair manual re macros. Not too helpful.

2. I did search the forum. I didn't find a similar thread.

 

About six months ago, I previously "programmed" a very simple macro that executed a 10 character string (just letters & numbers, nothing unusual). I assigned it to G13. All worked fine.

 

Recently, another software program (not Corsair CUE) caused a boot drive failure. So I did a clean install of Windows 10. That went fine.

 

Installed CUE and imported profile backup. Old shortcuts run fine. Old macros won't run at all. I can see and edit them; none run. I can create a new macro; it won't run. FYI: I assign the macros to the G keys.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...