tballan48 Posted December 30, 2004 Share Posted December 30, 2004 I recently bought TWINX1024-3200C2PT to go with my Asus P4P800-E Deluxe mobo with the latest BIOS (1004). I am running an Intel 3.2E Prescott and I do not OC and have no plans to OC. Here is my issue. The memory is listed as 2-3-3-6 T1. However, I went into BIOS and told my mobo to load defaults and this is what is set in the bios (with all the possible values listed): Advanced/Jumper Free Configure DRAM Timing by SPD: Enabled / Disabled (defaulted to Enabled) DRAM cas # latency: 2.0 / 2.5 / 3.0 (defaulted to 2.5) DRAM ras # precharge: 4 / 3 / 2 (defaulted to 4) DRAM ras # to cas # delay: 4 / 3 / 2 (defaulted to 4) DRAM precharge delay: 8 / 7 / 6 / 5 (defaulted to 8) DRAM burst length: 8 / 4 (defaulted to 8) Memory acceleration mode: Auto / Enabled (defaulted to Auto) DRAM idle timer: Inifinite / 0T / 8T / 16T / 64T / Auto (defaulted to Auto) DRAM refresh rate: Auto / 15.6 usec / 7.8 usec / 64 usec / 64T (defualts to Auto) I am not sure what the default values are set for the following because I didn't realize that the RAM Guy might need this info...I am at work right now instead of home: Advanced/Jumper Free AI Overclocking CPU Freq DRAM Clock Memory or Dim Reference voltage System performance USB Legacy Support Questions: 1) My understanding is that the BIOS gets the settings from the memory chips so why did it set 2.5-4-4-8? 2) What should I set the values above for this RAM that is listed as 2-3-3-6 in the Corsair spec sheet? I am out of breath right now...waiting to see what you guys say. Troy Link to comment Share on other sites More sharing options...
This topic is now archived and is closed to further replies.