St.Lucian Fury Posted December 29, 2004 Share Posted December 29, 2004 Hi, I am building a new system: - ASUS P4P800SE - P4 3.0E Prescott - Two 512 mb corsair value select PC3200 (VS1GBKIT400C3) I would like to run them in dual channel mode, but with both sticks installed in any combination (dual or single channel) the system will not post. With EITHER chip installed in any of the 4 dimms it boots fine. Any help would be greatly appreciated. Note: I don't know what version BIOS I am running, but plan to flash it with the latest tonight. Thankyou Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted December 30, 2004 Corsair Employees Share Posted December 30, 2004 Please go to the bios setup and load setup defaults and then set the timings and Frequency manually to whats listed bellow and then test the system with http://www.memtest.org. CPU Freq: 200 MHz Memory Frequency: 200MHz/400DDR Dim Voltage to 2.75 Volts SDRAM CAS Latency: 3T SDRAM RAS to CAS Delay (tRCD): 4T SDRAM Row Precharge (tRP): 4T SDRAM Active to Precharge Delay (tRAS): 8T Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.