Jump to content
Corsair Community

H100i vanished from CL v4.2.2.27


otterspace

Recommended Posts

I have an H100i with a Lighting Node (running firmware 0.9) and it doesn't behave itself with CL v4.2.2.27

 

I managed to set up some behaviours for temp etc. But after a profile change it just gives up and stays at whatever colour wants!

The H100i's LED seems ok. But the LED strips attached to the Lighting Node are not.

 

 

Anyone had any issues with the lighting node?

 

Thanks

Link to comment
Share on other sites

I have an H100i with a Lighting Node (running firmware 0.9) and it doesn't behave itself with CL v4.2.2.27

 

Did this use to work with an earlier version of CL and if so which version?

 

I suspect the 0.9 firmware may be too old. The H100i should be 1.1.3 and the Lighting Node 1.1.9, but CL4 can't update firmware.

 

I would install CL 3.2.5742 and update the firmware. If you get the endless reboot see http://forum.corsair.com/forums/showthread.php?p=822047

Link to comment
Share on other sites

Thanks for the quick reply red-ray.

 

It sort of worked in CL3... I won't go into the issues CL3 had, but basically I'll give your firmware suggestion a go.

 

To be honest, it seems to be behaving this morning so I might just treat it as I did CL v3... like a house of cards!

 

Set it up. Don't touch it. Expect it to fall down now and again! ;)

 

Thanks

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...