Jump to content
Corsair Community

H100i V2 Pump Dimensions


drop24

Recommended Posts

I don't know if anyone from Corsair has these available or if someone could please measure a unit that is not installed. I'm trying to figure out if the pump will fit through a case grommet hole to go to the other section of the case so I can have the rad separate from the motherboard section. I'd need the thickness of the pump from the cold plate to the top and the width of the widest side. Thanks.
Link to comment
Share on other sites

Thanks Red-ray! Just to confirm that's 80mm wide at the widest and 42 mm thick from the bottom of the coldplate to the top of the plastic shroud?

 

Yes, had it not been I would not have said it was :confused:. The 42mm is the size of hole needed and is actually the distance from the inside of the pipes to the outside bottom of the coldplate. It's 34 mm from the bottom of the coldplate to the top of the plastic shroud.

 

How big is the hole/what case is it?

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...