Jump to content
Corsair Community

Corsair utility Engine macros not working whatsoever


JHatter

Recommended Posts

I'm getting the exact same thing with a K70 RGB and Sabre RGB. Macros worked fine on my M65 a few days ago, but the Sabre and K70 now refuse to run any macros. In addition, assigning macros to the Sabre seems to remove the ability to use mouse4 and mouse5, unless macros are assigned to those buttons.
Link to comment
Share on other sites

have you tried repairing CUE by running the installer again? Did it resolve anything?

 

I had.

 

I uninstalled it then reinstalled it and done a system restart, seems to be working fine now. This problem has happened a few times though and I'd much rather not have to uninstall and reinstall it over and over when the problem appears

Link to comment
Share on other sites

I just ran a repair on my installation, and I think it's working correctly now. I have yet to test it in games, which is where the biggest problems were, but I can now configure my mouse with side buttons for tab switching and mouse8 as a double-click with no problems. I'll post another reply if I have anything more to add.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Guest
This topic is now closed to further replies.
×
×
  • Create New...