cmusgrove Posted December 23, 2004 Share Posted December 23, 2004 I just built a new computer Some specs are PNY nvidia 6800 GT MSI K8T neo 2 motherboard BIOS 3.2 AMD 64 3500+ 90 nm version 4 x CMX512-3200C2 I had some problems early on, but fixed those. Now when I run memtest86 http://www.memtest.org/ I get an error around 150-151M in test 3 when writing 40404040. I've changed the settings around the mem modules a little, I could experiment more, but the result seems to always be the same. Can someone tell me what I need to set my memory settings to in the BIOS? I'm running the memory at 333 with a latacy of 3. I know I should have bought the TWIN, but didn't know at the time. Is there anyway I can change these out for TWINs? I know I shouldn't do 2 questions in one post but here I do it anyways. Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted December 23, 2004 Corsair Employees Share Posted December 23, 2004 Please check MSI's site as there is a new version of bios 3.2 that will work with the 90nm CPU's and the settings for four modules would be as follows. CAS Latency CL=2.5 Row Cycle Time tRC Bios Default Row Refresh Cyc Time tRFC Bios Default Ras# to CAS# delay tRCD 3 Row to Row delay Bios Default Min Ras# Active Time tRAS 7 Row Precharge Time tRP 3 Write Recovery Time Bios Default Write to Read delay Bios Default Read to Write Delay Bios Default Refresh Period tREF Bios Default Enable 2T Timing Enabled Then test the system with http://www.memtest.org and make sure it's stable! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.