Jump to content
Corsair Community

I Need the SPD info and TRC Values (The Timing)


Recommended Posts

I have Two CMX512-3200C2PT sticks of RAM and i have an asus A8V Deluxe MB. I am running a 939 socket AMD 64 3200+. After calling asus they told me to ask u for the TRC Values. I put then in Ram slot 3 b/c that is the only way my computer will boot up and i get the values 2.5-3-8-3 and 3.0-3-8-3. I am not sure what that order is in a row but that is how it goes from top to bottom of the bios display. I really need these values. I put up a post last night and it was deleted. I would appreciate a response.
Link to comment
Share on other sites

  • Corsair Employees

Please try and install the modules in slots 2-4 and the enter the bios setup and load setup defaults and set the following settings with the Dim Voltage set to 2.7 Volts and then test the system again one module at a time to be sure.

CAS Latency CL=2.5

Row Cycle Time tRC Bios Default

Row Refresh Cyc Time tRFC Bios Default

Ras# to CAS# delay tRCD 3

Row to Row delay Bios Default

Min Ras# Active Time tRAS 6

Row Precharge Time tRP 3

Write Recovery Time Bios Default

Write to Read delay Bios Default

Read to Write Delay Bios Default

Refresh Period tREF Bios Default

Enable 2T Timing Disabled

Then test the system with http://www.memtest.org and make sure it's stable! If you get errors then lets try replacing your modules.

Please send us a email with a copy of the form or all of your info name address and phone# and the Module part# and copy the link to this post and email it to Warranty@corsairmemory.com. Or you can also use the On Line RMA Request Form as well.

If after 1 day or 24 hours excluding weekends you do not get the rma please email the same to rma@corsairmemory.com and we will help to resolve it.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...