SenAtsu Posted February 18, 2016 Share Posted February 18, 2016 Hello! Attempting to fashion up a push pull config for my H100i liquid cooler. Seems like I have to pick up an extra 4 screws, but they seem quite thin for the fans. There is considerable movement between the screw and the fan, and I'm afraid this might cause the entire fan to shake? The screws that came a long with the cooler also seems a bit short to get through the holes properly to attach it safely to the top of my case. Please view the attached images, and put my worries to rest. Thank you! Link to comment Share on other sites More sharing options...
DeathAngel74 Posted February 18, 2016 Share Posted February 18, 2016 8 6-32 1 1/4" will do the job, if you mount it at top of the case as exhaust. http://www.overclock.net/content/type/61/id/2707880/ i used longer screws to mount the fans beween the case's top grille and the radiator. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.