windrunr Posted December 21, 2004 Share Posted December 21, 2004 I purchased Corsair VS1GBKIT400 1GB Kit DDR400 PC3200 CAS2.5 memory based Corsair's website recommendation that is used in a new Shuttle SN95G5 computer powered my an AMD 64bit 3000 procesor. I can not get the SN95G5 to recognize the memory beyond initial memory check. It does not identify Corsair memory in the POST. When I stick an old PC 2100 256mb memory stick it sees the memory configuration. Was your recommendation to use Corsair VS1GBKIT400 1GB Kit DDR400 PC3200 CAS2.5 memory appropriate for the Shuttle SN95G5 computer? Rod Link to comment Share on other sites More sharing options...
Wired Posted December 21, 2004 Share Posted December 21, 2004 The recommendation stands, it just may be a bad stick unfortunately. Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted December 27, 2004 Corsair Employees Share Posted December 27, 2004 Please put the memory module on slot 1&3; make sure that you have the latest BIOS for your MB, and set the following settings on your BIOS; VS1GBKIT400 or VS512MB400 Memory Configuration: Memclock Mode: Limit Memclock Value: 2:1 (DDR400) Bank Interleaving: 4/Enabled Burst Length: 4 SDRAM CAS Latency: 2.5T SDRAM RAS to CAS Delay (tRCD): 3T SDRAM Active to Precharge Delay (tRAS): 8T SDRAM Row Precharge (tRP): 3T Hypertransport: 4X Jumper Free/Frequency Voltage Control: Spread Spectrum: Enabled CPU FSB Clock: 200 DDR Voltage: 2.7/2.75 Volts All other settings should be set to default settings! Then please test them one at a time with http://www.memtest.org and let’s make sure it's not some other issue! I would run the test for at least 2-3 passes to be sure! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.