Narbie Posted December 17, 2004 Share Posted December 17, 2004 oopssssssssssssssss Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted December 18, 2004 Corsair Employees Share Posted December 18, 2004 Please put the memory module on slot 2&4 or 1&3 (try either one); make sure that you have the latest BIOS for your MB installed, and set the following settings on your BIOS; Advanced Chipset: Memclock Mode: Limit Memclock ratio: 2:1 (DDR400) Bank Interleaving: 4/Enabled Burst Length: 4 SDRAM CAS Latency: 2.5T SDRAM RAS to CAS Delay (tRCD): 3T SDRAM Active to Precharge Delay (tRAS): 6T SDRAM Row Precharge (tRP): 3T Hypertransport: 5X Jumper Free/Frequency Voltage Control: AI OverClock: Manual Spread Spectrum: Enabled CPU FSB Clock: 200 DDR Voltage: 2.7/2.75 Volts All other settings should be set to default settings! Then please test them one at a time with http://www.memtest.org and let’s make sure it's not some other issue! I would run the test for at least 2-3 passes to be sure! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.