caitsai Posted December 13, 2004 Share Posted December 13, 2004 Hi, I have a 1 memory CMX256A-27002PT and Motherboard Asus A7N8X-X E And i have a problem when in install Windows (it's start but after copy file i have a BSOD IRQL NOT LESS OR EQUAL) so can't install ! Then I test my memory with memtest and it find lot of bad block ! So now what can i do thanks Link to comment Share on other sites More sharing options...
CMC_SAVAGE Posted December 13, 2004 Share Posted December 13, 2004 What CPU are you using in that board? It would help if you list the BIOS settings for the RAM and CPU. Link to comment Share on other sites More sharing options...
caitsai Posted December 14, 2004 Author Share Posted December 14, 2004 My Proc is Athlon XP 1700 And the set in the bios is default ! 133MHZ and the memory don't touch because don't understand Link to comment Share on other sites More sharing options...
Wired Posted December 14, 2004 Share Posted December 14, 2004 The memory speed needs to be set to 133 Mhz as well (may say 266 Mhz). Link to comment Share on other sites More sharing options...
caitsai Posted December 14, 2004 Author Share Posted December 14, 2004 But how to set up the CAS ... how to setup the voltage of memory ? Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted December 14, 2004 Corsair Employees Share Posted December 14, 2004 You might try over at http://www.asusforums.org for help with the bios and or contact the MB maker's tech support. But all of the options should be listed in your bios setup. DRAM Voltage 2.7 Volts suggested DRAM Timing (overrides SPD values): Manual System Performance: Normal SDRAM Bank cycle time (or tRAS): 6 SDRAM Bank Interleave: 4 SDRAM Row Precharge (tRP): 3 SDRAM RAS-to-CAS Delay (tRCD): 3 SDRAM CAS Latency: 2 Command Rate: 1T All other settings are motherboard defaults. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.