xms2700c2 & k8v se deluxe

[keithmcp]

I just got a k8v SE deluxe with A64 3400+ with bios 1004. I have two sticks cmx512-2700c2 in it. Right now they are in slots one and two and timings are all set to auto(except for auto/limit and mem to cpu ratio(5:3 DDR333)). My question is should I use the same memory timings that you recommend for the 3200c2(DDR 400) or different ones?

 

I have seen the following in other posts:

 

CAS 2.0/2.5 (seen in different posts for DDR 400)

Bank Interleaving 4

TRC Auto

TRFC Auto

TRCD 3

TWR Auto

TRWT Auto

TRAS 6

TRP 3

DDR Clock delay Auto

 

Should CAS be 2.0 or 2.5?

What about TWR & TRWT, I saw nothing about them.

Is DDR Clock dealy same asn Command Rate?

What should voltage be?

 

Thanks for the help.

[RAM GUY]

Please put the memory module on slot 1 & 3; make sure that you have the latest BIOS for your MB, and set the following settings on your BIOS;

Advanced Chipset:

Memclock Mode: Limit

Memclock Value: DDR333

Bank Interleaving: 4/Enabled

Burst Length: 4

SDRAM CAS Latency: 2.5T

SDRAM RAS to CAS Delay (tRCD): 3T

SDRAM Active to Precharge Delay (tRAS): 7T

SDRAM Row Precharge (tRP): 3T

Hypertransport: 4X

Jumper Free/Frequency Voltage Control:

Spread Spectrum: Enabled

CPU FSB Clock: 200

DDR Voltage: 2.7/2.75 Volts

All other settings should be set to default settings!

Then please test them one at a time with http://www.memtest.org and let’s make sure it's not some other issue! I would run the test for at least 2-3 passes to be sure!