Chervas Posted August 29, 2014 Share Posted August 29, 2014 Hi, I have a h100i and intel i7. But I think that the temperature is too hot and I cant feel warm the radiator or cables from the bump. I'm using windows 7 See the temperature in this snapshot Link to comment Share on other sites More sharing options...
Dwindleflip Posted August 29, 2014 Share Posted August 29, 2014 Well the h100i temp is about right. The cpu temp is a little high for 20% usage. To give you a comparison I have an i7-4960x and it idles at 30-35c in this summer weather and its 60c on full load at 4.6 overclock. Link to comment Share on other sites More sharing options...
Synthohol Posted August 29, 2014 Share Posted August 29, 2014 What motherboard? Sometumes on some boards the capacitors are too close to the socket and interfere with proper mounting. Also the backplate notches must face the right way or it also causes uneven mounting. To also rule out a software glitch pleas check the temps in the bios for 5 minutes. Please let us know :) Good luck. Link to comment Share on other sites More sharing options...
Chervas Posted August 29, 2014 Author Share Posted August 29, 2014 What motherboard? Sometumes on some boards the capacitors are too close to the socket and interfere with proper mounting. Also the backplate notches must face the right way or it also causes uneven mounting. To also rule out a software glitch pleas check the temps in the bios for 5 minutes. Please let us know :) Good luck. I have a ASUS MAXIMUS VI Impact, and I'm not overclocking. I compared the bios temperature with the corsair link monitoring, and is the same. The backplate seem good placed. How can I test if the bump is working?? How is the noise produced by the bump?? Link to comment Share on other sites More sharing options...
harryhoudini66 Posted September 6, 2014 Share Posted September 6, 2014 I have a ASUS MAXIMUS VI Impact, and I'm not overclocking. I compared the bios temperature with the corsair link monitoring, and is the same. The backplate seem good placed. How can I test if the bump is working?? How is the noise produced by the bump??The Impact board is very thin. It even comes with some washers for mounting the backplate. Did you use them for your install? Some people using Mini ITX boards like myself, encountered issues due to the board being too thin. This caused the backplate to fit too loose. I ended up having to install some washers and my temps went down. Here is a video I made on the subject. Other causes are people installing the backplate incorrectly. http://www.asus.com/Motherboards/MAXIMUS_VI_IMPACT/ [ame] [/ame] Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.