autotech Posted August 17, 2014 Share Posted August 17, 2014 I have 2 x 240 gig gt I installed toolbox but it shows me no info and wont even run trim manualy. Is this normal. smart status is blank. Link to comment Share on other sites More sharing options...
Toasted Posted August 18, 2014 Share Posted August 18, 2014 This is normal since the two drives are in a RAID array. If the drives are not in a RAID array, the toolbox should be able to detected them individually and properly. Link to comment Share on other sites More sharing options...
autotech Posted August 18, 2014 Author Share Posted August 18, 2014 They do separately I just wanted to make sure it was normal when in raid. As far as I know there is no way to run trim without toolbox and I am used to doing that at least once a week. I also like seeing the smart status. Speeds are great but I didn't do it for speed I did it for room. Link to comment Share on other sites More sharing options...
Yellowbeard Posted August 18, 2014 Share Posted August 18, 2014 TRIM is supported on the Intel controller you have, in RAID-0. No need to manually run it. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.