Texshooter Posted August 1, 2014 Share Posted August 1, 2014 I have a CORSAIR Hydro Series H60 (CWCH60) where do I plug the pump and where do I plug the pump's fan? I assume the pump's fan goes to CPU_FAN and the pump goes to SYS_FAN. Is this correct? Link to comment Share on other sites More sharing options...
HOODedAssault Posted August 1, 2014 Share Posted August 1, 2014 I always put pump to cpu_fan so if pump fails you'll get cpu fan error. Link to comment Share on other sites More sharing options...
Nick779 Posted August 12, 2014 Share Posted August 12, 2014 Just make sure the pump is always run at 100% 12V and not undervolted Link to comment Share on other sites More sharing options...
MojoVersion8 Posted August 13, 2014 Share Posted August 13, 2014 motherboards tend to want to throttle cpu_fan based off the cpu temperature (though these days it's often configurable) so it's usually best to plug your fan into that and the pump into anything else as long as it does (or can be set to) run at full speed since the pump wants a constant 12V Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.