yadnom1973 Posted May 8, 2014 Share Posted May 8, 2014 Hi I have a out of balanced cooling with my fans of which there are 4 then the 2 from a H100i and one more in the PSU. I have corsair link and it controls the fan in my PSU and my H100i but not the other fans. I can get it to see 3 of them which is almost there but changing the values dose nothing? I could do it all in the Ai suite but It cant control the H100i, I also cant understand the custom curve, why dose it only go up to 70c and how do you know the temp or RPM value of a given point. I tried to find a manual for it on line if anyone knows where I could find one? Link to comment Share on other sites More sharing options...
yadnom1973 Posted May 8, 2014 Author Share Posted May 8, 2014 It's all gone to 0's again, everything reads 0's. I cant get it to reliably use a curve even on the H100i fans. If I could just find a way to control the fans on the cooler, even a simple quiet/normal/turbo would be enough. Link to comment Share on other sites More sharing options...
yadnom1973 Posted May 8, 2014 Author Share Posted May 8, 2014 It's not all 0's if i scroll down there's a whole new set of dials reading the correct numbers and reacting to input I just have all these old ones hanging about on the diagram of the case? Link to comment Share on other sites More sharing options...
wytnyt Posted May 8, 2014 Share Posted May 8, 2014 what you've done is a re-install leaving the old profiles on the computer so now it picks up 2 sets...you can try deleting but if they continue to show,a re-install is needed and making sure you delete the apps/corsair folder... Link to comment Share on other sites More sharing options...
yadnom1973 Posted May 9, 2014 Author Share Posted May 9, 2014 That makes sense though I'd be surprised I managed to uninstall and missed the program folder. Will try, thank you. So far so good, the stray dials have gone for nwo and I have a power page too, it's an amazing little program but still no ability to control the fans? only the H100i fans and the PSU fan which can only have a fixed rate or default, if i put on default it just turns off. Link to comment Share on other sites More sharing options...
wytnyt Posted May 9, 2014 Share Posted May 9, 2014 try using h100i to control your fan speed,it works for me in all my builds... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.