Rastin Posted April 20, 2014 Share Posted April 20, 2014 Hi I just got my H100i about a week ago and have not had much luck with it. my idel temp is at 55c. have tryed downloading the link program and it does not do much that i can tell. it asked for an update so i did and now it will not see the pump speed reads 0. before it read 257 wich is low from what i have read from other posts. is there a way to increase the speed? my board is msi z87-gd65 with a i5-4670k not over clocked new build. let me know what other info you need. also had to disable it from the boot menu in bios it kept tring to boot as my hard drive. and when in bios my temp shoot up to 99c witch is not good. Link to comment Share on other sites More sharing options...
wytnyt Posted April 20, 2014 Share Posted April 20, 2014 look in bios and see what the pump reads,it should be ~2200rpm Link to comment Share on other sites More sharing options...
Rastin Posted April 20, 2014 Author Share Posted April 20, 2014 In the bios it does not see it as a pump but as a fan. with the rpm at 296 Link to comment Share on other sites More sharing options...
HOODedAssault Posted April 20, 2014 Share Posted April 20, 2014 The cable is just a signal wire. Try plugging the H100i power sata into another cord from psu. If that doesn't give you the 2200rpm it's supposed to run at then request rma or go and swap it at your retailer for another. Link to comment Share on other sites More sharing options...
Rastin Posted April 20, 2014 Author Share Posted April 20, 2014 I can't beleave that worked. pluged in to a differant power cable and it worked temp is down to 28. now it makes me wonder about my power supply. Thanks for the help Link to comment Share on other sites More sharing options...
HOODedAssault Posted April 20, 2014 Share Posted April 20, 2014 Sata and mole power cables are a very stupid design in my opinion. Like something out of knob and tube days. I'm not surprised. May of just been how it was hooked up. Prob connect it back to original one n it would work lol. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.