Search the Community
Showing results for tags 'vengeance pro'.
Found 2 results
-
HI, I bougth 3 LL120 with Ligthning node pro and 2 stick of RAM Vengeance Pro (2x32Gb). It was a great error. Lightning control is very difficult. My problems: 1) LL120 can be controlled only by Links (Aura works sometimes but a lot of times doesn't see the devices, ICUE install and opens but doesn't detect any device -> years of device not detected ... maybe is the time to correct the issue). 2) Vengeance not detected by links or iCue and in this way not controllable at all. The question is: Is there a solution? Maybe someone could think no, you have hardware conflict, incompatibiliy and so on but ... BUT ... OPENRGB sees all devices perfectly and allows to manage fans and ram perfectly. This program create only basic effects and I would like to use iCue. Why don't you fix your bugs? Regards, Luca PS OpenRgb is written by an enthusiast programmer not payed. Do you understand?
-
Hello, This is regarding Corsair Vengeance RGB Pro After the update to v 3.5.111 from 3.4.95 Before I was able to set one dimm to sequential and the LED effect will have same speed as before. After the update the LED speed will slow down a lot and look kinda laggy unless all 4 dimms runs sequential mode. I liked the when it ran fast, because I could do some awesome effects where each dimm had it's own sequential effect and it will just look cool. You can find a video I recorded of the "laggy" effect here -> https://photos.google.com/share/AF1QipNpSl_wmAzrEmGH-U42xSznxZl2XQR2MlDxCZ7gr7NhN62rvBTWyRJf3jgMROnp1Q?key=WnVDdVdwaWdTQVppTjNuXzB5NmRDWFpuZzB5d3dB It's actually so bad (not recorded in the video) that when I use sequential on dimm 1&2 and new sequential 3&4 then dimm 2&3 are out of sync of each other. In the previous version they both ran smooth as **** and visually in sync.
