Hey all,
I just received my 2 Commander Pros in the Mail. I replaced my thermaltake ones and hooked up 10 fans, 4 temp sensors, 4 light strips. They are all functioning.
But when I go into the iCue software, only the Commander Pro that is directly connected to my MOBO shows. So if I want to check the temp of my GPU (All GPU fans/temps on 2nd commander) , it does not show. My 1st commander (All CPU fans/lights/etc)
is showing and able to be controlled fine.
Do I need to do anything special to get them both to show? I've read several places on the forum that its fine to have multiple and to daisy chain them.
Any Suggestions?