synesthesia92 Posted June 6, 2019 Share Posted June 6, 2019 Hi everyone, Having an issue with my LL fans. I have: 2 x 8GB Vengeance Pro RGB Then connected through the Commander Pro: 2 x Lighting Node Pro RGB strips 2 x LL120 fans 1 x LL140 fan I've had no issue with the RGB until this week (built my PC before Xmas). I turned off all the RGB using instant lighting for a few hours, but when I switched everything back on, the Vengeance Pro and lighting nodes all came back on fine, but the fans didn't light back up. I think it's still picking up the fans in ICUE (I can switch lighting modes in ICUE, and it shows up on the preview of the fans on screen), but it's not carrying across to the fans themselves. I've updated all my software etc. Does anyone have any ideas? Thank you in advance. Link to comment Share on other sites More sharing options...
Corsair Employee Corsair Calico Jack Posted June 6, 2019 Corsair Employee Share Posted June 6, 2019 The fans are never detected, they have to be set in iCUE to work. Try doing this: https://support.corsair.com/app/answers/detail/a_id/77/kw/clean Can we get a screenshot of your lighting setup options and what you have set to the fans? Link to comment Share on other sites More sharing options...
synesthesia92 Posted June 13, 2019 Author Share Posted June 13, 2019 Thanks for your reply. This is what it currently looks like in iCUE - fans are all listed but no lights seem to be working. Link to comment Share on other sites More sharing options...
c-attack Posted June 13, 2019 Share Posted June 13, 2019 In your screen shot, the top Spiral Rainbow is not applied to the fans. I can't tell what's going on with the lighting link effect below. It only takes one stray click to de-select your lighting. You can CTRL + click drag to box all the fan LEDs. The graphic will highlight yellow to indicate it is applied. Link to comment Share on other sites More sharing options...
synesthesia92 Posted June 16, 2019 Author Share Posted June 16, 2019 Hi - thanks for your advice. I highlighted all the Fan LEDs in the preview and applied the spiral rainbow effect (see attached) but the fans themselves are still not lighting up. Is there anything I am missing here? Link to comment Share on other sites More sharing options...
Waukeen Posted June 17, 2019 Share Posted June 17, 2019 Awesome, someone else who found an issue with instant lighting. Went playing around with it a couple days ago and when I tried to switch back to a profile the lighting refused to switch from the instant setting and I was forced to restart ICue to get it to start working properly again. The only thing you might want to try as I cannot see the setup you have, make sure the fans are configured correctly for the CoPro/LNP as that could be related to what is happening in your case. Or it's the fully beta tested, passed without an issue, 'no problem to see here' software performing just this side of a train wreck. Link to comment Share on other sites More sharing options...
synesthesia92 Posted June 19, 2019 Author Share Posted June 19, 2019 So miraculously my fans have come back on today, not sure if there's been an iCue update or something. Might not work again tomorrow for all I know, so will post if it changes. Link to comment Share on other sites More sharing options...
Recommended Posts