Fredinhidef Posted July 30, 2018 Share Posted July 30, 2018 I have 6 LL120 fans-RGB connected to 1 HUB, and PWR connected to Comamander pro. 1 LL120 connected to HUB and PWR connected to MOBO. Both hubs connected to commander pro. 4 LED strips going to Node with USB going to Commander PRO. and last but not least 4 temp sensor's coming out of Commander PRO. I finally got all RGB LED on fans and strips to work correctly and in order (and that took me entirely to long lol.) So my problem is the first 6 fans- they power on at boot and spin for about 1-2 seconds and then stop. LED's however continue to go. I checked PWR and it seems fine. I must be missing something. Any help is much appreciated. THANKS IN ADVANCE Link to comment Share on other sites More sharing options...
DevBiker Posted July 30, 2018 Share Posted July 30, 2018 How are the fan curves for the LL fans configured in iCue/Link? Can you provide a screen cap? How are you powering the Commander Pro? Straight SATA or molex-to-SATA adapter? Link to comment Share on other sites More sharing options...
Corsair Employee Corsair Lettuce Posted July 30, 2018 Corsair Employee Share Posted July 30, 2018 It sounds like you have everything connected correctly, as DeBiker asked how is are you power the unit? Are you currently using the iCUE software or Corsair Link? Link to comment Share on other sites More sharing options...
Fredinhidef Posted July 30, 2018 Author Share Posted July 30, 2018 sorry just getting back home...straight to sata...before the commander pro I had (2) 3 way splitters from MOBO to the 6 LL120(since my MOBO only has 2 SYS FAN outputs) I am currently using iCUE software..what should i take a screenshot of? edit: ok here is some screenshots LMK if there is anything specific you need Link to comment Share on other sites More sharing options...
Fredinhidef Posted July 30, 2018 Author Share Posted July 30, 2018 I figured it out ..pretty easy...I must have been tired earlier. LOL it was under settings on the iCUE software the first 6 fans were in the drop down menu as disconnected I switched them to 4-pin and VOILA! Link to comment Share on other sites More sharing options...
DevBiker Posted July 30, 2018 Share Posted July 30, 2018 I figured it out ..pretty easy...I must have been tired earlier. LOL it was under settings on the iCUE software the first 6 fans were in the drop down menu as disconnected I switched them to 4-pin and VOILA! :headbang::headbang::headbang::headbang: Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.