Jump to content
Corsair Community

TR3X3G1600C8D + Asus P6T


Salv0

Recommended Posts

Hi all! : )

 

I currently have 3GB corsair Dominator ( 1GB x 3 DDR3 1600 TR3X3G1600C8D ) on my Asus p6T board, working with XMP.

Now my question is: I want to use 64bit OS so I want 6GB of ram...can I buy another set of 1GBx3 ( exactly the same as mine ) and populate all the 6 slots on my p6t?

Will this config works at 1600 obviously with XMP?

 

Thanks in advance :)

Link to comment
Share on other sites

  • 4 months later...

Hi everyone,

i've read this information about the Asus P6T and the Rams TR3X3G1600C8D.

My question: works the solution from Ram Guy also for the P6T SE?

in the manual on Page 3-17 are a table and the Settings 1.4-1.7 are under the red column(risk Level).

 

Also on the Dimm-Sockets at the Mainboard was an sticker with the following:

According to Intel CPU SPEC,DIMMs with voltage setting over 1.65V may damage the CPU permanently. We recommend you install the DIMMs with the voltage setting below 1.65V.

 

So i'm a little bit uncertain, will it works fine with the P6T SE / CPU:i7-920 / 2x TR3X3G1600C8D ?

 

Thnaks for an Answer

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...