Pe8er Posted July 9, 2014 Share Posted July 9, 2014 Hey guys, The pump on my H100i is much louder than it should be. As advised on the forums here, I waited for a week to see if it settles in. Nothing changed. I also swapped the fan connector and power connector, to no avail. Tapped on the pump — nothing happened. Updated to firmware 1.0.7. It’s not the fans, as I swapped those out for a couple NoiseBlockers, which are extremely quiet. I have submitted a support ticket #6490822 a few days ago, can you please look into it? Link to comment Share on other sites More sharing options...
sandstorm1 Posted July 9, 2014 Share Posted July 9, 2014 are you running the rad over the pump or under it? Link to comment Share on other sites More sharing options...
Pe8er Posted July 9, 2014 Author Share Posted July 9, 2014 It’s a rather typical setup, I imagine: http://imgur.com/5Nbv97p.jpg Link to comment Share on other sites More sharing options...
Nichrome Posted July 13, 2014 Share Posted July 13, 2014 It doesn't quite matter how you run the setup. And yes, for h100i this is most common way of fitting it. I would RMA this, as VERY loud pump is something bad and shouldn't happen. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.