shine6 Posted November 11, 2013 Share Posted November 11, 2013 Hi Guys, I purchased a Corsair H100 a while ago, running fine, and now I just got a Corsair Link Commander with Cooling node. I also have a brand new RM850 PSU. I connected the H100 on the Link commander. Here is what I get on the software: - 2 FANs (3 & 4) reading 9952 and 1028rpm (!) - 1 pump, reading 6425 (!!) - 2 x Temps (1 & 4), reading 0°C each (!!!) The readings doesn't look correct to me, and I should have 1 temp for cooling water, not 2. Strangely the H100 is well detected in device panel. Regarding the RM850, the LInk cable is connected on the Link Cooling node (3 pin fan + 2 pin probe). I never got the fan detected (perhaps it never started), and the power reading is about 5A, which quiet a bit low :). Cooling node version is 1.2.11. Link version is v2.4.5110. Commander firmware is 2.0.6. Profile reset and PC restart do not help. Any idea what could be wrong? Thanks in advance! http://hpics.li/951a4cc http://hpics.li/b11549f http://hpics.li/5dafef2 SHine Link to comment Share on other sites More sharing options...
Toasted Posted November 11, 2013 Share Posted November 11, 2013 Have you tried reinstalling the software? Delete the profiles here and create a new one: %appdata%\Corsair Link to comment Share on other sites More sharing options...
shine6 Posted November 11, 2013 Author Share Posted November 11, 2013 Yes, did try both. No change I am afraid ... Link to comment Share on other sites More sharing options...
AndyBroke Posted November 11, 2013 Share Posted November 11, 2013 I have the exatc same problem with the h100. I was using windows 8.1, so I was thinking that was the problem and installed windows 8. Still no luck. I sent a message to corsair this weekend. So lets hope they can give me an answer. Link to comment Share on other sites More sharing options...
shine6 Posted November 11, 2013 Author Share Posted November 11, 2013 I opened a case too. That really looks like a SW issue ... Link to comment Share on other sites More sharing options...
shine6 Posted November 30, 2013 Author Share Posted November 30, 2013 Well, after a RMA, I installed the replacement part and ... it works. At least with Link 5.4.5065. It seems there would be an issue on pump temp with 5.1 version but I am not sure. I note that replaced H100 firmware version is 1.1.12. Thanks to Corsair support! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.