snowball666 Posted October 17, 2018 Share Posted October 17, 2018 On 2 of my 5 fans. Judging by sound they are actually spinning under 900RPM. They speed reported fluctuated between 3,000 and 20,000 RPM. Mostly staying in the 5-8K range. I forced a firmware flash on the commander pro, and installed todays iCUE update. With no change. EDIT: these are 3 pin fans, stetting panel auto or 3pin makes no difference. Fans are rated for 1,900RPM at 12V They are reported correctly and are controlable when not connected to the commander pro. Link to comment Share on other sites More sharing options...
c-attack Posted October 17, 2018 Share Posted October 17, 2018 Usually when you see impossible values reported, there is a software conflict with another monitoring program. Are you running AIDA, HWiNFO, AI Suite or something similar? Link to comment Share on other sites More sharing options...
snowball666 Posted October 17, 2018 Author Share Posted October 17, 2018 Usually when you see impossible values reported, there is a software conflict with another monitoring program. Are you running AIDA, HWiNFO, AI Suite or something similar? Nothing else running. Did a restart and checked task manager processes. Link to comment Share on other sites More sharing options...
c-attack Posted October 17, 2018 Share Posted October 17, 2018 If software conflict is ruled out, then it's probably time to move the two misreporting fans. Swap 5 & 6 with 1 & 2 and see if the erroneous speeds travel with the fan or stay on the headers 5 & 6. There have been a few fans that don't seem to do well with the Commander Pro. It would be good to find out if it's that or a bad unit. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.