Kimmerdreng Posted April 5, 2014 Share Posted April 5, 2014 Hello .. I've just attached my laing ddc-1t 10w pump to my cooling node. I can now see rpm readings. But I cant control it, when I set it as "pump". When I set it as "fan", I can control it like a fan. But if I set the "fixed %" to etc. 95%, it goes down to 95% for 5 sec, then it goes to 0 rpm, and turn back on at 100%. I've tried the same in "fixed rpm", and the same happens. What do I do wrong here? :sigh!: Link to comment Share on other sites More sharing options...
Toasted Posted April 7, 2014 Share Posted April 7, 2014 The Cooling Node was not designed to control pumps. What you can try do is check for the latest firmware and see if that helps. I'd be careful with the Cooling Node as its discontinued. Meaning getting a replacement may not be possible. Link to comment Share on other sites More sharing options...
Kimmerdreng Posted April 7, 2014 Author Share Posted April 7, 2014 I´m using firmware 1.2.5 on my node. And that´s the newest, as far as I know. Link to comment Share on other sites More sharing options...
Toasted Posted April 9, 2014 Share Posted April 9, 2014 Newest FW for the Cooling Node is FW 1.2.11 http://forum.corsair.com/v3/attachment.php?attachmentid=12731&d=1369442071 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.