Zaza73 Posted January 28, 2020 Share Posted January 28, 2020 Can 1000d fit 480 80mm in Front? Link to comment Share on other sites More sharing options...
gienah Posted January 29, 2020 Share Posted January 29, 2020 The distance from the raised screw holes on the front tray to the rear compartment bulkhead and the drive bay is 120mm. If the ports are on the bottom, then you need to figure out if the fittings and tubes will fit, you may want to run the front radiators in parallel. There is a clash in the inside top front corner with the top radiators/fans. If the ports are on the top, then this makes the clash worse. Link to comment Share on other sites More sharing options...
usna92 Posted February 7, 2020 Share Posted February 7, 2020 Math wise looking at mine, it should fit with about 15-ish mm to spare with one set of fans. You will not be running push-pull on that huge radiator which will likely result in poor thermal efficiency. I would look in the 50-60 mm range that would still let you run push-pull and give you some clearance for fittings. -usna92 Link to comment Share on other sites More sharing options...
Recommended Posts