Jimmy79 Posted September 14, 2019 Share Posted September 14, 2019 I just started assembling my new computer and immediately ran into an issue. The alignment tabs on the motherboard I/O shield do not match the cutouts for them in the case. Design issue or manufacturing issue on one component or the other? It's hard to see in the pic, but I can try to get better if needed. Motherboard: Gigabyte X570 Master Case: Corsair 570X Link to comment Share on other sites More sharing options...
Saffronman Posted December 30, 2019 Share Posted December 30, 2019 I have a similar problem, motherboard connectors do not align to the connector shield, check pictures. I will not be able to connect USB/ connectors etc without damaging the shield. I did screw the M/B down! 1. I have checked that the motherboard PCB is straight - all OK 2. I tried to check that the screw pillars/standoffs are a similar height - all OK 3. If i press very slightly in the connector area, it does align but that is because the M/B frame can flex. 4. The centre standoff near the connector edge can be removed/changed, I could remove it and check The installation guide does not match the case, the middle mount is a locating/alignment pin for the M/B and not a pillar for a screw as shown in the guide (page 12). I was looking forward to this build but I'm stuck at the first step:(: HELP! any ideas or is this a manufacturing problem. Link to comment Share on other sites More sharing options...
Recommended Posts