zihanzzz Posted July 12, 2017 Share Posted July 12, 2017 Hi, I have a question regarding turning off HD120 LED. I (am going to) have the following configurations: 1 x Corsair 570X case (comes with a 6 port RGB Controller) 4 x HD120 RGB fans 1 x Commander Pro If I plug in all fan connectors to Commander Pro, all rgb wires to RGB Controller, and plug rgb controller to Commander Pro. Now I should be able to see all fans in my Corsair Link Dashboard. I have two questions regarding this: 1. Can I manually turn each fan off in Corsair Link? 2. Can I turn off the fan's LED? I have seen so many people who said it couldn't be turned off. But those people are not connecting their fans to the motherboard at all! With this configuration, I see in Corsair Link there is a brightness option, will that turn off the LED if I set to minimum brightness? Other than the brightness, is there any other way to turn off the LEDs? Please share your advice. Thank you very much. Link to comment Share on other sites More sharing options...
SpeedyV Posted July 12, 2017 Share Posted July 12, 2017 I don't know if Link can turn the HD-RGB fan LEDs off. I can turn them off using SIV by setting the LED Mode to Static Color then setting color to R-0, B-0, G-0. Perhaps this can be done in Link also. I don't know because I don't use Link. Maybe someone who does use Link could chime in here. Good luck!! Link to comment Share on other sites More sharing options...
red-ray Posted July 12, 2017 Share Posted July 12, 2017 I can turn them off using SIV by setting the LED Mode to Static Color then setting color to R-0, B-0, G-0. The best way to do this was to use Menu->Tools->Configure->Link Setup and set the port brightness to 0%. As from SIV 5.21 You could also export say 0% + 100% Lighting Profiles then use a hotkey to switch profiles. After pondering this I felt you should be able to have user defined hot keys to turn the LEDs off and restore the default brightness :biggrin:. I also added Menu->Profile->Set LEDs Off + Menu->Profile->Set LEDs Default. If you prefer to use suboptimal software then CL4 should be able to do this. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.