KSH Posted November 24, 2020 Share Posted November 24, 2020 So I´ve recently built myself a new rig. Everything is working fine except for the fact that one of the fans on the cooler is stuck on a high rpm. This has made the rig quite loud, and I'm worried it will shorten the life span of the fan. I have tried updating the iCue software, and making a custom fan curve. But none of these things worked. I can adjust fan 1 and 3 just fine. Number 2, just ignores all orders from iCue. I have double-checked that all the cables are plugged into the right places and everything. Unsure what to do now. Any ideas? Link to comment Share on other sites More sharing options...
c-attack Posted November 24, 2020 Share Posted November 24, 2020 Pop #2 off the splitter and then re-connect it. Sometimes you don’t get good contact on all of the pins. If that does not change things, swap fan 2 with either #1 or #3 on the cable. You are looking to see if the problem follows the fan to the new connector (problem with the fan) or now applies to the “new” #2 (problem with splitter or controller). This is a H150i XT, correct? Link to comment Share on other sites More sharing options...
Recommended Posts