mfalske Posted November 18, 2020 Share Posted November 18, 2020 i have a 2x8 corsair rgb pro, i have it set to the custom wave settings with 7 colors. i am trying to figure out the tail and velocity along with lights per second. every configuration, after it cycles the rgb flickers and then resets. does anyone know the right settings for this? Link to comment Share on other sites More sharing options...
c-attack Posted November 18, 2020 Share Posted November 18, 2020 Your lighting time is too low. At 3 seconds, it will only advance 2.0 LEDs/sec according your instruction. So it would go about 3/4 of the way and then it would start over again. Try 7 seconds for total lighting time (for 2 LED/s and tail 5). You can then add another 1-2 seconds if you want a pause in between the finish and re-start of the wave. Link to comment Share on other sites More sharing options...
Recommended Posts