4le Posted January 12, 2016 Share Posted January 12, 2016 Hi everybody, I've just buy a H100i GTX but the 2 fans included dont like me; in my case there are all Corsair Led Series and the 2 of the radiator are grey with no led. Is it possible to buy two fan with led and 4 pin (with the same value of air flow, static pressure and speed)? I have just try a SP120 Led but they don't fit in plug in 4 pin pump connectors and the upper mentioned values are very different. I'm very disapponted about that. Link to comment Share on other sites More sharing options...
Datakiller24 Posted January 12, 2016 Share Posted January 12, 2016 Hi everybody, I've just buy a H100i GTX but the 2 fans included dont like me; in my case there are all Corsair Led Series and the 2 of the radiator are grey with no led. Is it possible to buy two fan with led and 4 pin (with the same value of air flow, static pressure and speed)? I have just try a SP120 Led but they don't fit in plug in 4 pin pump connectors and the upper mentioned values are very different. I'm very disapponted about that. Hi, Corsair currently don´t have any PWM (4PIN) LED fans as I see. You can try to find something else (CM JetFlo 120 ... there are more, just search a bit :) ). Maybe ... a bit later Corsair will have also their PWM LED fans designed for coolers. BR, Peter Link to comment Share on other sites More sharing options...
4le Posted January 12, 2016 Author Share Posted January 12, 2016 Very bad; it's a pitty because in the stock fans there are the place for 4 led 5 mm; if I found the purple ones i mounted in original fans. Is pcb predisposed for the leds? If not i connected by external If only blade fan was neutral.... The led purple are ultraviolet (wlenght >300nm) or normal violet (wl 390 -400 nm)? Link to comment Share on other sites More sharing options...
4le Posted January 26, 2016 Author Share Posted January 26, 2016 Done! I not found the same colour of my fan (violet) but the cyan is not too bad... http://s9.postimg.org/tmo3s7hzz/image.jpg http://s2.postimg.org/6r1efrgxl/image.jpg Sorry for the photos quality, I'm a very bad photographer... Link to comment Share on other sites More sharing options...
Datakiller24 Posted January 27, 2016 Share Posted January 27, 2016 Look good! Maybe You can share with others what You needed and how You done it ;) Regards, Peter Link to comment Share on other sites More sharing options...
4le Posted January 27, 2016 Author Share Posted January 27, 2016 Very low difficult job... The stock fan has 4 place for led; find the led 5 mm of the colour you like (if avaiable of course). Put 4 led in fan place, glue (I use hot glue), solder the wire as chart below and isolated all the led pins. If possible try the led before mounting the fans. I have a fractal define R5 case which have a 3 male plugs for additional 3 fans with a dedicadet switch. I solder a female fan plug in every stock fan and done....external connection full reverseble.. http://s16.postimg.org/61t25t7th/image.png http://s17.postimg.org/94x1nvzfj/image.jpg http://s10.postimg.org/5340ihqyx/image.jpg http://s14.postimg.org/9sbhcycbl/image.jpg http://s11.postimg.org/9oioavgxf/image.jpg http://s30.postimg.org/xxx6hmyr5/image.jpg Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.