russiandivxclub Posted September 21, 2014 Share Posted September 21, 2014 Hello got myself brand new X99 system and everything works except Corsair Link. Long story short is this. Right after install before first reboot everything works. I see and can change LED, can see both fan RPM and RPM of the block ( I wonder where they get RPM from if it's a water block ? ... no matter) I also see in Device information everything proper, like what fans connected to block connected pump and temp sensor. Once computer restarted everything have to do with H100i is not visible. Can't control LED, can't see both fans RPM and no RPM info for a block. Here are pics. Freshly installed Corsair Link Software All fans working Also I can Control FANS and LED Under Device info I see information. After reboot No fans or LED readout No Device Information , just saying version And last thing, and this shoot taking BEFORE restart, what's with firmware upgrade to EXACT same version ? I am not sure what is going on but it's clearly software isuue cause hardware works, color works and fan readout works .... BEFORE I restart. Thank you, too bad I had to start post 1 with problem but I hope this is rare one. Link to comment Share on other sites More sharing options...
Speed Posted September 22, 2014 Share Posted September 22, 2014 I wonder where they get RPM from if it's a water block ? The water block contains the pump. Link to comment Share on other sites More sharing options...
wytnyt Posted September 22, 2014 Share Posted September 22, 2014 don't fret using your first post asking for help,,that's why the board is here;): the problem you have is likely a usb issue since it worked when installed.you can check and make sure other usb devices are not interfering and if this doesn't help you can use a usb/mini usb cable and connect to a outside rear port. hope this helps,if not just post back Oh,and welcome to the board... Link to comment Share on other sites More sharing options...
Darkom Posted September 22, 2014 Share Posted September 22, 2014 don't fret using your first post asking for help,,that's why the board is here;): the problem you have is likely a usb issue since it worked when installed.you can check and make sure other usb devices are not interfering and if this doesn't help you can use a usb/mini usb cable and connect to a outside rear port. hope this helps,if not just post back Oh,and welcome to the board... yeah i also has that problem in the past, i removed all the usb cables in the front of the case and it was solved. Link to comment Share on other sites More sharing options...
red-ray Posted September 23, 2014 Share Posted September 23, 2014 Can the system talk to the H100i at all? You could run SIV (http://rh-software.com/) and see that [uSB Bus] reports. If it's saying error 31 (like http://forum.corsair.com/forums/showthread.php?p=729495#post729495 is) then it's either a poor connection or hardware issue. Can you try the H100i on a different PC or at least a different USB port. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.