shimeng Posted August 1, 2018 Share Posted August 1, 2018 http://media.bestofmicro.com/corsair-obsidian-900d,C-7-380167-22.jpg The rubber bung surrounding the drive tray retaining pins have decayed and can no longer hold a hard drive captive. Corsair does not sell the pins and I'm unwilling to shell out $20 plus shipping for a new drive tray. Anyone else with the same issue? Any suggestions for some kind of replacement for the pin? Link to comment Share on other sites More sharing options...
snapper69 Posted August 1, 2018 Share Posted August 1, 2018 It's a while since I looked, but aren't there 4 holes in the bottom of the tray (like the one in the picture) that you can use to screw the HDD in place? Failing that, remove the bung and use screws and washers. Link to comment Share on other sites More sharing options...
Corsair Employee Corsair Caliente Posted August 1, 2018 Corsair Employee Share Posted August 1, 2018 It's a while since I looked, but aren't there 4 holes in the bottom of the tray (like the one in the picture) that you can use to screw the HDD in place? Failing that, remove the bung and use screws and washers. There are four holes at the bottom of the tray but they're meant for SSD mount and won't line up with the HDD. Washers and screws would seem like your best bet at this point. Link to comment Share on other sites More sharing options...
Rockhound00 Posted March 25, 2019 Share Posted March 25, 2019 I have the same problem. I'm thinking about trying these out as a solution. Any thoughts? https://www.coolerguys.com/products/hard-drive-screws-with-rubber-washer-black-set-of-4 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.