Jump to content
Corsair Community

2 F-40s in raid 0 & firmware update


davidBuby

Recommended Posts

Can the 2.0 firmware be done in raid set-up ? I formerly had update when used

in AHCI , when using 1 of the F-40s as the boot drive . The HD Tune Pro showed that my raid set-up has firmware 1.1 . My tests showed very good results . I'm just wanting to get the best out of my investment . So what should I do to update ?

Link to comment
Share on other sites

Understood . The 2 F-40s in raid cannot receive firmware update while in raid configuration , or any other storage device .

 

Also, there is no performance improvement from the older firmwares to the 2.0. If you are not having issues, there is no need to upgrade.

Link to comment
Share on other sites

The firmware needs to be done to each drive individually which is not possible

when in raid . I will be hoping for other methods to work . You all do a very good job on your forum , and I want to thank you all for all your efforts .

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...