Badgerslayer7 Posted September 23, 2019 Share Posted September 23, 2019 Hello. Just recently built a system with an Asus x570 hero. I have 6 ml pros connected to a commander pro with 2 temp sensors connected to a water loop which are also connected to the commander I have set a custom fan curve in icue to the first water sensor. Everything works as expected. The issue I have is when the computer boots before press f2 bios screen. The fans spin full speed up until point which is slightly annoying. Is there a setting I’m missing that can help with. Any help would be much appreciated. Thanks Link to comment Share on other sites More sharing options...
c-attack Posted September 23, 2019 Share Posted September 23, 2019 Within iCUE, go the Settings -> Commander Pro device and then change the setting for your ML fans from Auto to 4 pin. When on auto, it will do a fan test (the full 12v blast) on each restart. Link to comment Share on other sites More sharing options...
Badgerslayer7 Posted September 25, 2019 Author Share Posted September 25, 2019 Ah mate. I can’t believe that’s all I had to do. I would never have found that setting. Thank you. Link to comment Share on other sites More sharing options...
Recommended Posts