Jump to content
Corsair Community

Testing Command Pro & Lighting Node Core


Tex_Recoil

Recommended Posts

Hello all,

been a few years since I Upgraded or even messed with my system. So I Jumped right in, bought a Commander Pro and Update all my fans to Ql's which came with the Light Node Core. Question I have is testing to make sure everything hooked up right and working, on my new PC build. I haven't yet received my Z490 dark MB yet as it back ordered. I'm wanting to test out the fans and RGB without the Commander Pro hooked up to a MB usb port. Is it possible without damaging anything? or do I need to wait on the Mb to hook it all up to a usb port? Any help you can give me, would be great. Also hope this is the right forum to post this in. Thanks.

Link to comment
Share on other sites

With a 24 pin jumper on the main PSU cable you still have the SATA power needed to turn on the Core. The fans should default to a rainbow pattern and you can verify they all light up, but control will require the iCUE software and a fully functional system for the initial set-up.
Link to comment
Share on other sites

×
×
  • Create New...