Jump to content
Corsair Community

Corsair Link 4.9.9.3 Reporting wrong fan speed


jesinfc

Recommended Posts

Did a search but didn't see anything on this. I have a case fan attached to a fan connector on my motherboard that Corsair Link detects, but it reports a fan speed of 4600 rpm when in fact it is running at a very low speed. Its reported at approx 800 RPM in other HW monitor software. Is there any way to get Corsair Link to report correctly? The Motherboard bios correctly reads the fan speed.
Link to comment
Share on other sites

  • 8 months later...

I know nobody has replied to this in 6+ months. But I have an update. It turns out that HWinfo64 monitor software correctly reads fan speeds for all 3 fans attached to my AORUS 390 Pro motherboard. But one of the 3 fans is reported in Corsair Link as exactly 2X the actual speed (Motherboard/Bios/HWinfo64 speed = 1043 RPM, CorsairLink speed = 2086 RPM). It would be useful if Corsair Link was able to apply a ratio (e.g. 50%) or divisor (e.g. 2) to any fan so it reports the right speed.

 

Does anybody know if this can be done via a config file or other setting not available through the Corsair Link GUI?

 

Thanks.

Link to comment
Share on other sites

×
×
  • Create New...